Intended Use; Safety Instructions - Pfaff HV 0516 Traduit Mode D'emploi

Hydraulic stacker - manual drive and lift F 08.01.114-1
English
Read the operating instructions carefully before using!
Follow safety instructions!
Keep document safe!

Intended use

The hydraulic stacker, with forks for independent lifting of loads, is intended for both manual lifting/lowering
and the manual transporting of loads. Its use requires a level and firm floor/ground surface.
The hydraulic stacker, with forks for independent lifting of loads, is intended for on-site transporting of unit
loads, e.g. in warehouses associated with industry and delivery companies etc., for short range transporting of
standard and wire mesh pallets as well as other palletised loads.
It is not suitable for use in potentially explosive locations.
It is not suitable for use in hostile environments.
Alterations to the hydraulic stacker and the addition of auxiliary units are only permitted with our express
written approval.
Ensure that you take note of the technical data and details on functional characteristics!
Regulations for prevention of accidents
The hydraulic stacker must be used and operated as intended and in accordance with relevant regulations.
1)
The current regulations of the country in which it is used must be complied with
In Germany these are currently:
EC Directive 2006/42/EC
German safety standard BGV D27 (available from Carl Heymanns Verlag, Cologne, Berlin)
EN 1757-1 Pedestrian propelled trucks – Stacker trucks
1)
in the respective current version
It is essential that the operating instructions below and the BGV D27 regulations for
prevention of accidents are carefully read through before starting use.

Safety instructions

Operation, assembly, and maintenance only by:
Instructed, qualified operators
(Definition of qualified operators in accordance with IEC 364)
Qualified operators are persons who, based on their training, experience, instruction and knowledge of the
relevant standards and regulations, regulations for prevention of accidents and operating conditions, are
authorised by the persons responsible for the safety of the plant to carry out the respective required tasks
whilst being able to recognise and prevent potential associated dangers.
 Operation is only permitted on a level and firm floor/ground surface.
 Transporting of persons and a presence within the danger zone is not permitted.
 A presence under a raised load is not permitted.
 The specified load capacity must not be exceeded.
 The loaded material must be distributed evenly on the fork.
 The hydraulic stacker must never be loaded whilst the fork is in a raised position.
 The high-lift pallet truck is not made for or capable of off-loading like a forklift truck or crane.
 Never leave the load unattended in a raised position.
 Never reach into moving parts.
 Defects are to be dealt with competently as soon as they become apparent.
 Only use genuine spare parts.
Inspections
In accordance with Section 37 of the BGV D27 the hydraulic stacker must be inspected by a
competent technical expert at least once per year, and otherwise as required.
We recommend that you record the results of the inspections in an inspection book.
8 / 20
technische Änderungen vorbehalten subject to change without notice changements techniques sous réserve