Cleaning And Maintenance; Technical Specifications - HQ Power XMT60 Manuel D'utilisation

• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, lamp
explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Installation of the Lamp
• Only fit or replace a lamp when the device is unplugged from the mains.
• Let a lamp cool down before replacing it as the temperature of a lamp can reach 700°C during operation.
• When handling a halogen lamp, do not touch it with your bare hands. Use a cloth to insert or remove it.
• Do not install lamps with a higher wattage. They get hotter than this device was designed for.
• Replace any deformed or damaged lamp with a lamp of the same type (see "7. Technical Specifications", p2):
1. Unscrew the 4 screws at the bottom of the housing and carefully open the housing.
2. Unscrew the nut on the colour wheel and remove them.
3. Loosen the clamp holding the lamp fixation in.
4. Replace the lamp.
5. Replace the lamp fixation using the clamp.
6. Replace the colour wheel and tighten the nut.
7. Close the housing and tighten the screws.
Remark: Do not operate the device when the cover is open.
5. Use
• Make sure the power switch of the device is set to OFF.
• Insert the adaptor jack into the base of the device.
• Insert the adaptor plug into the mains.
• Set the power switch of the device to ON. The tree will light up and will start to display beautiful changing colours.

6. Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.
2. The housing, the lenses, the mounting supports and the installation location (e.g. ceiling, suspension, trussing)
should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting supports, do not
change the location of the connections, ...
3. Mechanically moving parts must not show any signs of wear and tear.
4. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
5. Disconnect the device from the mains prior to maintenance activities.
6. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7. There are no user-serviceable parts, apart from the lamp (see "4. Installation of the Lamp" above).
8. Contact your dealer for spare parts if necessary.

7. Technical Specifications

Power Supply
Power Consumption
Dimensions
Total Weight
Lamp
Max. Ambient Temperature
The information in this manual is subject to change without prior notice.
XMT60
max. 12VAC, 1A/12W
max. 12W
∅ 330 x 600mm
1,2kg
12V/10W MR11
45°C
2 VELLEMAN