Troubleshooting - Spring 58 9840 25 31 Mode D'emploi

10

troubleshooting

Problem
Induction cooktop does not turn
on.
The ON/OFF lamp blinks and the
cookware does not get warm.
Heat suddenly goes off during the
cooking process.
The heat is too low.
The wireless remote control doesn´t
work.
In case of malfunctions or questions of any kind, please contact your service center or directly:
Spring International GmbH
Höhscheider Weg 29
D-42699 Solingen
Germany
www.spring.ch
Possible cause
1. No power input
2. Internal defect
1. The cookware is not suitable
for induction cooking or the
diameter is too small.
2. The cooking container is not
in the middle of the ceramic
surface.
1. The induction cooktop is inter-
nally overheated.
2. The temperature of the cookware
is too high because it was used
while empty.
1. The cookware is not flat or the
material is unsuitable
1. The battery is empty.
2. Internal defect
solution
1. Plug the power cord into a
suitable socket. Make sure the
socket has the proper voltage.
2. Contact your dealer or service
office.
1. Use appropriate cookware acc.
to Chapter 5.
2. Make sure the cookware is
centered on the rings on the
ceramic surface.
1. Ensure good air circulation as
described in Chapter 4.1.
2. Carefully remove the cookware
from the ceramic surface and
allow the appliance to cool
down.
1. Use suitable cookware as
described in Chapter 5.
1. Replace the battery.
2. Contact your dealer or service
office.
GB
35