Safety Precautions - Grohe Sensia ARENA 39354SH0 Manuel D'installation

GB

Safety Precautions

For safe installation and use of the product,
please read the precautions thoroughly
before installing the product.
DANGER
Denotes an immediately hazardous
situation, which may result in death or
severe injury if not prevented.
WARNING
Denotes a potentially hazardous situation,
which may result in death or severe injury if
not prevented.
CAUTION
Denotes a potentially hazardous situation,
that may result in mild to moderate injuries
and/or damages to the product and/or other
items and property if not prevented.
DANGER
Improper connection of the power
socket can result in a risk of electric
shock.
All electrical installation work must
be carried out by a qualified
electrician.
There is a danger of short circuit
and/or electric shock.
The protective zones must be
assured in bathrooms.
If a power supply connection is made
in zone 2, then the power supply to
the Shower Toilet can be established
by a direct connection, using a
connector socket IPX4 as permanent
connection.
8
GB
WARNING
Follow the instructions described in
this manual, and install the product
properly.
Failure to do so may cause electric
shock, fire, injury, water leakage,
and/or flooding.
Do not allow anyone except an
authorized service technician to
disassemble, repair, or modify the
product.
There is danger of electric shock or
fire, and the product could
malfunction, causing injury.
Do not connect or disconnect the
power socket or power cord with wet
hands.
There is a danger of electric shock.
Hold the socket when connecting or
disconnecting the power socket.
If the socket is connected or
disconnected by holding the cord,
there is a danger of fire or electric
shock due to the socket or cord
becoming damaged.
Do not pour water or the cleanser
inside or onto the toilet seat unit,
remote control, or power socket.
It may cause electric shock or fire.
Do not use any power supply other
than AC 220 V - 240 V. Also, do not
use any other method to connect the
socket to an improperly configured
receptacle.
Exceeding the rated voltage for use
may cause an electric shock or fire.
Electrical installation work must only
be performed by a qualified
electrician. This work must be carried
out in accordance with the
regulations according to IEC 60364-
7-701 (corresponding to VDE 0100
Part 701) as well as all national and
local regulations.
Be sure to insert the tip of the wires
of the power cords securely into the
inlets of the power socket.
Failure to do so may cause fire.
Connect the power socket
completely.
There is a danger of fire or electric
shock due to the cord becoming
damaged.