afx light PIXCOLOR Manuel D'utilisation page 5

ELECTRICAL INSTALLATION FOR TWO OR MORE UNITS IN DMX MODE
Use this function when you want to control the projectors by any DMX controller.
Connect the projectors as shown in the drawing below.
• First put the projectors in the desired DMX mode: see the different DMX charts and choose the one
that suits you best.
• Give all projectors a start address: each projector shows its start + end address, make sure that the
addresses do not overlap.
DMX Chart
9-Channel Mode:
DMX channel Value Function
1 0-255 Dimmer
2 0-255 Strobe
3 0-255 Red for SMD5050
4 0-255 Green for SMD5050
5 0-255 Blue for SMD5050
6 0-255 White for CREE led 3W
7 0-255 Built-in effects 1
8 0-255 Built-in effects 2
9 0-255 Speed for built-in effects Slow to fast
10 0-255 Color control of CH8
11 0-255 Sound Control
20-Channel Mode:
1CH 0-255 Dimmer for All
2CH 0-255 Strobe
3CH 0-255 Programme 1
4CH 0-255 Programme 2
5CH 0-255 Programme Speed
6CH 0-255 Control the color of Programme 1
©Copyright LOTRONIC 2018
Remarks
Dimmer for all lights
Strobe for all lights
CREE LED Effects, last is auto running
SMD5050 effects, last is auto running
PIXCOLOR
Page 5