Possible Causes - Whirlpool 3LWTW5550 Guide D'utilisation

TROUBLESHOOTING
If you experience
Vibration or Off-Balance
Check the following
for proper installation
or see "Using Your
Washer" section
Noises
Clicking or metallic
noises
Gurgling or humming
Humming
Water Leaks
Check the following for
proper installation:
Washer not performing as expected
Not enough water
in washer
Washer won't run
or fill, washer stops
working or wash light
remains on (indicating
the washer was unable
to fill appropriately)
First try the solutions suggested here to possibly avoid a service call.

Possible Causes

Feet may not be in contact with the
floor and locked.
Washer may not be level.
Load could be unbalanced.
Objects caught in washer drain
system.
Washer may be draining water.
Load sensing may be occurring.
Washer not level.
Fill hoses not attached tightly.
Fill hose washers.
Drain hose connection.
Check household plumbing for
leaks or clogged sink or drain.
Washer not loaded properly.
Load not completely covered
in water.
Check for proper water supply.
Front and rear feet must be in firm contact with floor, and
washer must be level to operate properly.
Check floor for flexing or sagging. If flooring is uneven, a 19mm
(3/4") piece of plywood under your washer will reduce sound.
See "Level the Washer" in Installation Instructions.
Load garments in loose heaps evenly around the washplate.
Adding wet items to washer or adding more water to basket
could unbalance washer.
Wash smaller loads to reduce imbalance.
Use Bulky Item cycle for oversized, non-absorbent items such as
jackets and small comforters.
Empty pockets before washing. Loose items such as coins
could fall between basket and tub or may block pump.
It may be necessary to call for service to remove items.
It is normal to hear metal items on clothing such as metal snaps,
buckles, or zippers touch against the stainless steel basket.
It is normal to hear the pump making a continuous humming sound
with periodic gurgling or surging as final amounts of water are
removed during the Spin/Drain cycles.
You may hear the hum of the sensing spins after you have started
the washer. This is normal.
Water may splash off basket if washer is not level.
Tighten fill-hose connection.
Make sure all four fill hose flat washers are properly seated.
Pull drain hose from washer cabinet and properly secure it to
drainpipe or laundry tub.
Water can back up out of a clogged sink or drainpipe. Check all
household plumbing for leaks (laundry tubs, drain pipe, water
pipes, and faucets.)
Unbalanced loading can cause basket to be out of alignment and
cause water to splash off tub. See "Using Your Washer" for loading
instructions.
This is normal operation for an HE low-water washer. The load will
not be completely under water. The washer senses load sizes and
adds correct amount of water for optimal cleaning. See "What's
New under the Lid."
IMPORTANT: Do not add more water to washer. The added water
lifts the load off the washplate, resulting in less cleaning.
Both hoses must be attached and have water flowing to inlet valve.
Both Hot and Cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water flow.
Solution
13