Battery Charger Safety; Safety Instructions For Maintenance; Assembly - RedMax BHB250P Manuel D'utilisation

Masquer les pouces Voir aussi pour BHB250P:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Keep batteries in storage away from metal objects
such as nails, screws or jewelry.
Keep the battery away from children.

Battery charger safety

WARNING: Read the warning instructions
that follow before you use the product.
Risk of electrical shock or short circuit if the safety
instructions are not obeyed.
Use an approved grounded mains socket that is not
damaged.
Do not use other battery chargers than the one
supplied for your product. Only use QC330ZR
chargers when you charge BLi200ZR replacement
batteries.
Do not try to disassemble the battery charger.
Do not use a defective or damaged battery charger.
Do not lift the battery charger by the power cord. To
disconnect the battery charger from a mains socket,
pull out the plug. Do not pull the power cord.
Keep all cables and extension leads away from
water, oil and sharp edges. Make sure that the cable
is not caught between objects, for example, doors,
fences or equivalent.
Do not use the battery charger near flammable
materials or materials that can cause corrosion.
Make sure that the battery charger is not covered.
Pull out the plug to the battery charger if there is
smoke or fire.
Only charge the battery indoors in a location with
good airflow and away from sunlight. Do not charge
the battery outdoors. Do not charge the battery in
wet conditions.
Only use the battery charger where the temperature
is between 5 °C (41 °F) and 40 °C (104 °F). Use the
To assemble the tube on the product
1. Put the blower nozzle over the tubular end of the
product.
8
charger in an environment which has a good airflow,
dry and free from dust.
Do not put objects into the cooling slots of the
battery charger.
Do not connect the battery charger terminals to
metal objects as this can short circuit the battery
charger.
Use approved mains sockets that are not damaged.
Make sure that the cord of the battery charger is not
damaged. If extension cables are used, make sure
that the extension cables are not damaged.

Safety instructions for maintenance

Remove the battery before you do maintenance,
other checks or assemble the product.
The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
If you do not do maintenance, it decreases the life
cycle of the product and increases the risk of
accidents.
Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
Only use original spare parts.

Assembly

2. Push the blower nozzle in fully and turn the blower
nozzle to lock it to the product.
WARNING: Read the warning instructions
that follow before you do maintenance on
the product.
471 - 004 - 04.09.2018

Publicité

Chapitres

Table des Matières
loading

Table des Matières