Beyerdynamic Amiron wireless Manuel D'utilisation page 23

Amiron wireless – Headphones
FCC / IC Regulation
FCC ID: OSDAMIRON
Canada IC: 3628C-AMIRON
NOTICE:
This device complies with Part 15 of the FCC Rules [and with Industry Canada licence-
exempt RSS standard(s)].
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) his device must accept any interference received, including interference that may
cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement.
NOTICE:
Changes or modifications made to this equipment not expressly approved by
beyerdynamic may void the FCC authorization to operate this equipment.
Radiofrequency radiation exposure information:
For body worn operation, this phone has been tested and meets the FCC RF exposure
guidelines when used with the beyerdynamic accessories supplied or designated for this
product. Use of other accessories may not ensure compliance with FCC RF exposure
guidelines.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules
These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
– Reorient or relocte the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
23