Technical Data - Abus FU9075 Instructions D'installation

Training the key switch
1. The ABUS alarm system must be in programming mode.
2. Under "Zones", select "Allocation" and set the system to
learn mode. You see the message "(Re) Write" on the display.
3. Insert the key in the cylinder and turn it clockwise to its end
stop so that the red LED lights up. Keep the key in this
position.
4. After about 3 seconds, the red and green LED flash
alternately and the transmitter sends the learn message.
5. Check that the alarm system has recognised the detector.
6. Program no supervision for this detector.
7. Program the zone as "Latch KSW" zone type. If you
program the zone as "BlLatch KSW delay", the system
starts the exit delay time following activation.
8. Switch the alarm centre back to normal operating mode.

Technical data

Dimensions (surface fitting)
Protection type
Weight
Frequency
HF immunity
Modulation
Supervision
Battery
Battery lifetime
Ambient operating temperature
The manufacturer reserves the right to make technical
modifications without prior notice.
85 x 114 x 42mm (WxHxD)
IP55
450g
868.65 MHz
20V/m 80MHz–1GHz
AM
None
3.6V DC, Li battery type AA
Ca. 1 year
-10°C – 50°C
10