Turning on the Electronic Flash
Turning on the Electronic Flash
Attach an electronic fl ash to the camera, and then turn the camera on.
Control panel
AUTO CHECK lamp
ON/OFF button
CHARGE lamp
1
Press the ON/OFF button.
• The control panel display will turn on.
• To turn the fl ash off, press the ON/OFF button again.
• Replace the batteries if the CHARGE lamp does not light
after:
30 seconds (Alkaline batteries)
10 seconds (NiMH batteries)
• If the CHARGE lamp and AUTO CHECK lamp blink
simultaneously, batteries are running low. Replace the
batteries.
• The fl ash will enter sleep mode whenever the camera
enters sleep mode.
• If no operations are performed for approximately 60
minutes, the fl ash will turn off automatically. Press the
ON/OFF button to turn it on.
9
EN