Directions For Use - Sanremo Milano LX SAP Livret D'instructions

ENGLISH
a) To access this phase keep the button M5 on the first pushbutton panel on the left pressed for
over 5 seconds. The indicator lights of the buttons M5 start to blink continuously. Select the
caption corresponding to the amount required and press to dispense. The indicator light of
button M5 and that of the selected caption remain lit. When the required amount has been
dispensed, press the selected dispensing button again so that the control unit stores the data.
Repeat the above procedure for all 4 dispensing buttons on the pushbutton panel. A dispensed
quantity may also be set for the hot water button (M6) by repeating the above procedure. Upon
completion of the procedure, the remaining groups will automatically use the stored quantity. The
other groups may, however, be programmed independently by repeating the same procedure
as above after having programmed the first group on the left.
b) There are 2 safety systems inside the control unit designed to protect the electronic system and
the various parts of the appliance. If, upon pressing a dispensing button, the corresponding
indicator light starts blinking, this indicates a malfunction in the electronic system or lack of
water. For safety reasons, the dispensing of water stops after 4 minutes and in any case after 4
litres of water.
c) The MILANO LX SED electronics also offers the possibility of reproducing the pre-brewing effect
by wetting the coffee for 0.6 seconds and then stopping the subsequent brewing from starting
for 1.2 seconds. This optional is only applicable for single shots of coffee.
With the appliance switched off, put the on/off switch (D) to position 1 and at the same time keep
the button (M1) on the left-hand group pressed until the indicator light corresponding to the button
(M5) remains lit; then release the button (M1). Now put the on/off switch (D) to position 0 and then
to position 2 in order to store the operation.
With the appliance switched off, put the on/off switch (D) to position 1 and at the same time keep
the button (M2) on the left-hand group pressed until the indicator light corresponding to the button
(M5) remains lit; then release the button (M2). Now switch the appliance off and then on again
using the on/off switch (D) in order to store the operation.

DIRECTIONS FOR USE

Dispenser programming
To enable pre-brewing
To disable pre-brewing
21