Domo DO7106S Mode D'emploi page 38

3. Clean the upper part of the iron with a soft, damp cloth.
4. Wipe the water drops on the steam generator and the thermal insulation pads with a dry
cloth.
5. When not using the steam generator for a long time, pour out the water from the water
tank and place the iron on the thermal insulation pads to store the appliance.
6. Wind the steam hose and cord around the appliance and lock them into place with the
cord clamp.
CAUTION: Only use tap water (or 50% tap water and 50% demineralized water in case of hard
water) in your steam generator. Careful: softened water or demineralized water should be
absolutely avoided! In case of use of a "softener" and/or perfumed water, brown stains could
emerge, which would cause damage to the steam chamber.
DESCALING SYSTEM
· This device has an electronic system that checks the water hardness.
· The descaling cartridge will remove the hard water. Depending on how hard the water is
and how the device is used, the descaling cartridge will need to be replaced after3 monhs.
· Take the water reservoir out of the steam generator.
· Place a new descaling cartridge.
· Should you have no descaling cartridges handy, you may temporarily use a combination
of 50% tap water and 50% distilled or purified water to fill the device. Afterwards you can
continue ironing for a little while until your descaling cartridge arrives.
After you have replaced your descaling cartridge, it will take a little while before you get
steam out of your iron. This is normal and happens because your cartridge is still completely
dry and it takes a bit for all the water in the generator to pass through entirely. We advise you
to replace the descaling cartridge the night before you plan on ironing, making sure it's
drenched.
38
DO7106S