Waeco BordBar TB08 Notice D'utilisation page 17

BordBar TB08
 If the cooler is connected to the DC socket: disconnect the re-
frigerator or switch it off when you turn off the engine. Otherwise
you may discharge the battery.
 The cooling device is not suitable for transporting substances
which are caustic or contain solvents.
2.2 Operating the cooler safely
DANGER!
D
 Do not touch exposed cables with your bare hands. This applies
especially when operating the device from the AC mains.
CAUTION!
!
 Before starting the device, ensure that the power supply line
and the plug are dry.
NOTICE!
A
 Do not use electrical devices inside the cooler unless they are
recommended by the manufacturer for that purpose.
 Do not place the cooling appliance near naked flames or other
heat sources (heaters, direct sunlight, gas ovens etc.).
 Danger of overheating!
Always ensure sufficient ventilation so that the heat generated
during operation can dissipate. Make sure that the cooling ap-
pliance is sufficiently far away from walls and other objects so
that the air can circulate.
 Ensure that the ventilation openings are not covered.
 Do not fill the inner container with ice or fluid.
 Never immerse the cooling appliance in water.
 Protect the cooling appliance and the cable against heat and
moisture.
EN
Safety instructions
17