Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
10 Using a Harness
10 Using a Harness
10.1 Putting on and Adjusting the Single Harness
WARNING
To reduce the risk of injury from loss of control and contact
with the blades, always wear a proper harness.
You must install the barrier bar, wear a proper harness and
always grip the rear handle with your right hand and front
handle with your left hand. That means you must place the
single harness over your left shoulder when working with
this KombiTool.
To fit and adjust the single harness:
► Shut off the KombiEngine or switch off the KombiMotor
and remove the connecting cord.
1
2
► Adjust the length of the harness strap (1) so that the
carabiner (2) is about a hand's width below the top of your
hip.
► Attach the carabiner to the carrying ring (3) on the
KombiEngine/KombiMotor.
For battery powered KombiMotors there are also other types
of battery harnesses available. They are described in the
KombiMotor manual.
0458-811-8221-A
11 Checking the KombiTool
11.1 Checking the Blades
Before starting work, check the blades for damage and
excessive wear, @ 18.2.
► Shut off the KombiEngine or switch off the KombiMotor
and remove the connecting cord.
1
► Measure the following points on the blades:
– Length a
– Width b
2
– Angle c
3
► If the minimum length (a) is less than 0.4 in. (10 mm):
Reposition the blades, @ 17.5.
► If the minimum width (b) is less than 0.2 in. (5 mm):
Replace the blades, @ 17.4.
► If the filing angle (c) is not 45°: Sharpen the blades,
@ 17.6.
► If you have any questions: Contact a STIHL servicing
dealer for assistance.
English
a
c
b
13
Publicité
Chapitres
Table des Matières
