Environmentally Responsible Disposal - Maico AS 20 Notice De Montage

Nominal sizes [A], dimensions [B]...[E]
given in [mm]
A
AS 20 200 39
AS 25 255 40
AS 30 307 40
AS 35 360 40
AS 40 412 40
AS 45 465 41
AS 50 517 41
AS 60 622 42
7. Mounting
NOTICE
Shutter does not close properly, if it is
tensely installed.
To ensure the shutter functioning, only
mount the shutter on a flat surface.
● Make sure there is sufficient space to the
wall or ceiling.
● The supplied protective grille also serves
as a protection against accidental contact
for a fan in accordance with EN ISO 13857.
B C D
260 197
314 250
366 300
420 355
472 405
526 460
578 510
684 615
1. Open and align the shutter's lamellae.
2. Mark the fixing holes at the 4 drilling
positions. Drill the holes and then insert
the dowels.
3. Place protective grille on the rear side of
the shutter.
4. Screw the shutter, together with the pro-
tective grille, to the wall using 4 screws.
5. When installing in potentially explosive
atmospheres (zone 1 or zone 2) check
whether the shutter can be touched. If this
is the case, place a fine-meshed wire cage
(mesh size approx. 8 x 8 mm) around the
shutter and safely ground the wire cage to
avoid spark formation.
6. Run function test.
E
182
234
8. Cleaning
286
If required, the unit should be cleaned with a
338
dry cloth. The frequency with which it should
390
be cleaned depends on the ambient
442
conditions and the expected impairments.
494
To clean, swing the shutter's lamellae
upwards. Do not use aggressive, harmful or
598
easily flammable cleaning agents.
The shutter is maintenance-free.
9. Environmentally responsible
disposal
The unit and the packaging contain parts that
can be recycled, and should not end up in the
domestic waste.
Dispose of the packaging material in an
environmentally-friendly way, in compliance
with the regulations valid in the country where
you are.
At the end of its service life, dispose of the
unit in an environmentally-friendly way, in
compliance with the regulations valid in the
country where you are.
Mounting instructions │ UK
5