GYS PRESS 8T Mode D'emploi page 28

Translation of
the original
notice
GYSPRESS 8T
Once the rivet has been set, release the trigger. For 8T and 10T riveters press the trigger below.
GYSPRESS 8T
By tilting the adapter backwards, the rivet pins fall into the collecting bowl.
By leaning forward, the pins come out through the nozzle.
Pin collection:
To collect the pins, pull the lid off
the bowl.
Once the pins have been collec-
ted, put the lid back on until it
clicks.
Clamping jaws change:
Unscrew the nozzle with a span-
ner.
Replace the jaws 2 then,
position them in 3 to 120°.
Place 4 then 5 and then screw 1
with the keys (tighten well).
50KN BLIND RIVET ADAPTER FOR 10T RIVETER
GYSPRESS 8T PP
GYSPRESS 10T
1- Connection cone jaws M0042
2- Jaws 51522
3- M0043 jaw cone
Tightening
4- Spreader M0044
spanner
5- Spring 55189
GYSPRESS 10T GYSPRESS 10T PP
1- Bowl M0077
2- Lid M0078
3- O-ring 55262
4- O-ring 551211
GYSPRESS 10T Connect
3
1
4
1
5
4
2
EN
2
3