GYS PRESS 8T Mode D'emploi page 26

Translation of
the original
notice
To use the extension kit it is not necessary to use the pin collecting bowl.
The pins, once broken, come out at the front.
1. Screw on the jaw support 3 with the 2 spanners (tighten well)
2. Screw on nozzle holder 2 with the 2 spanners.
3. Screw on one of the nozzles adapted to the rivet to be set (included in the standard kit)
Ø3.2 ref : 065994 To facilitate the installation of the nozzles:
Ø3.5 ref : 066007 • 1- Position a rivet into the nozzle.
Ø4.0 ref : 066014 • 2- Insert the rivet with the nozzle into the assembled support.
Ø4.5 ref : 066021 • 3- Tighten the nozzle with a spanner.
Ø5.0 ref : 066038
1-
Blind rivet setting:
After fitting the appropriate nozzle, place the rivet as far as the nozzle end stop.
Place the rivet through the hole in the sheets to be riveted and press the riveter trigger according to the model below:
GYSPRESS 8T
Once the rivet has been set, release the trigger. For 8T and 10T riveters press the trigger below.
GYSPRESS 8T
By leaning forward, the rivet's pins come out through the nozzle.
50KN BLIND RIVET ADAPTER FOR 10T RIVETER
2-
GYSPRESS 8T PP
GYSPRESS 10T
3-
GYSPRESS 10T GYSPRESS 10T PP
EN
Clé de serrage
GYSPRESS 10T Connect