GYS PRESS 8T Mode D'emploi page 19

Translation of
the original
notice
KIT 1
BLIND RIVET INSTALLATION FOR SHANK DIAMETER UP TO 5 MM + SELF-PIERCE RIVET
EXTRACTION.
Assembly order of kit 1:
4
1- Insert nozzle 1
2- Screw the jaw support 2 with the 2 spanners (tighten well)
3- Screw the nozzle holder 3 with the 2 spanners
4- Screw one of the nozzles adapted to the rivet to be set:
Ø3.2 ref : 065994 To facilitate the installation of the nozzles:
Ø3.5 ref : 066007 • 1- Position a rivet into the nozzle.
Ø4.0 ref : 066014 • 2- Insert the rivet with the nozzle into the assembled support.
Ø4.5 ref : 066021 • 3- Tighten the nozzle with a spanner.
Ø5.0 ref : 066038
1-
5- Thread the recovery bowl
Blind rivet setting:
After fitting the appropriate nozzle, place the rivet as far as the nozzle end stop
Place the rivet through the hole in the sheets to be riveted and press the riveter trigger according to the model below:
GYSPRESS 8T
Once the rivet has been set, release the trigger. For 8T and 10T riveters press the trigger below.
GYSPRESS 8T
50KN BLIND RIVET ADAPTER FOR 10T RIVETER
2
3
2-
GYSPRESS 8T PP
GYSPRESS 10T
1
3-
GYSPRESS 10T GYSPRESS 10T PP
EN
Clic
5
Tightening spanner
GYSPRESS 10T Connect