GYS PRESS 8T Mode D'emploi page 25

Translation of
the original
notice
2/ Installation with the stroke
1. Measure the inside dimension of the blind rivet nut (A)
2. Measure the dimension of the flange thickness (B)
3. Measure the thickness of the sheet metal that is to receive
the blind rivet nut (C).
4. Adjust the result (D) with the formula on the adapter:
D = A – B – C
2.1 / Example :
Blind rivet nut M12 / Sheet metal thickness 2mm
1. Measure the inside dimension of the blind rivet nut (A) = 10.5mm
2. Measure the dimension of the flange thickness (B) = 2mm
3. Measure the thickness of the sheet metal that is to receive the insert (C) =
2mm
4. Adjust the result on the adapter
D = 10.5 - 2 - 2 = 6.5 mm
For a more precise adjustment, use the scale (in mm) and the grooves on the
wrench adjuster.
One turn of the wrench adjuster corresponds to 1.5mm of travel and there are
15 grooves on the nut.
5. Press the riveter control and wait for the riveter to wedge.
6. Release the trigger and check that the insert is correctly in place.
7. To remove the pull pin from the blind rivet nut, unscrew with the rear wrench
adjuster.
Incorrect adjustment of the tool stroke can lead to incorrect tightening of the blind rivet nuts and breakage of the tie rod.
The adjustment of the stroke is essential for the fixing of the blind rivet nut.
It must be considered that an excessive stroke can cause the breakage of the tie rod, while an insufficient stroke does not guarantee
the stability of the blind rivet nut.
It is advisable to go in stages, increasing the stroke as you go along.
3 / Blind rivet bolts installation:
A dimensional measurement for deformation is not possible when installing blind rivet bolts.
It is advisable to go in stages, increasing the stroke as you go along.
KIT 3
EXTENSION FOR BLIND RIVET INSTALLATION FOR SHANK DIAMETER UP TO 5 MM +
SELF-PIERCE RIVET EXTRACTION.
Assembly order of kit 3:
1
50KN BLIND RIVET ADAPTER FOR 10T RIVETER
2
A
B
D = 10.5 – 2 – 2 = 6.5 mm
3
EN
C
A groove
=
0.1 mm