Build Worker BMS801-190 Traduction Des Instructions D'origine page 40

SERVICE DEPARTMENT
_ Damaged switches must be replaced
by our after-sales service department.
_ If replacing the power cord is
necessary, it should be done by the
manufacturer or his agent to avoid a
hazard.
After-sales Service and Application
Service
Our after-sales service responds to
your questions concerning
maintenance and repair of your
product as well as spare parts.
Exploded views and information on
spare parts can also be found
under:www.eco-repa.com
BUILD WORKER application service
team will gladly answer questions
concerning our products and their
accessories : sav@eco-repa.com
CARRYING TOOL
Make sure that the tool is unplugged.
Secure the blade at 0° bevel angle and
the turn base at the full right miter
angle position.
Lower the handle fully and lock it in the
lowered position by pushing in the
stopper pin.
Carry the tool by holding both sides of
the tool base as shown in the figure. If
you remove the holders, dust bag, etc.,
you can carry the tool more easily.
CAUTION:
• Always secure all moving portions
before carrying the tool. If portions of
the tool move or slide while being
carried loss of control or balance may
occur resulting in personal injury.
STORAGE
_ Thoroughly clean the whole machine
and its accessories.
_ Store it out of the reach of children,
in a stable and secure position, in a
cool and dry place, avoid too high and
too low temperatures.
_ Protect it from exposure to direct
sunlight. Keep it in the dark, if possible.
_ Don't keep it in plastic bags to avoid
humidity build-up.
GUARANTEE
Refer to the enclosed guarantee
conditions
for the terms and conditions of
guarantee.
ENVIRONMENT
Should your machine
need replacement
extended use, do not
put it in the domestic
waste but dispose of
environmentally safe
Made in China
after
it in an
way.
2015