Functional Description - Build Worker BMS801-190 Traduction Des Instructions D'origine

20 - Check damaged parts.
- Before using the tool for other purposes, examine
it carefully to determine whether it will operate
correctly and accomplish its planned function.
- Check the alignment or locking of the moving
parts, and the absence of any broken parts or any
fixing and other conditions that are likely to affect
the operation of the tool.
- A protective guard or other damaged part should
be repaired or replaced by an approved
maintenance centre, unless stated otherwise in this
instruction manual.
- Have defective switches replaced by an approved
maintenance centre.
- Do not use the tool if the switch does not permit
change from the on state to the off state.
21 – Warning.
- The use of any accessory or any fixing other than
that or those recommended in this instruction
manual can present a risk of injury to persons.
22 - Have the tool repaired by a qualified person.
- This electric tool satisfies the corresponding safety
rules. Repairs should only be made by qualified
persons using original spare parts. Not doing this
can expose the user to significant danger.
Additional statements for mitre
saws
Safety measures
- Do not use damaged or deformed blades.
- Replace the table block when it is worn
- Only use blades recommended by the
manufacturer.
- Do not use saw blades made from high speed
steel.
- Wear suitable personal protective equipment, if
necessary, which could include:
- hearing protection to reduce the risk of
induced hearing loss
- eye protection
- respiratory protection to reduce the risk of
inhaling dangerous dusts
- gloves for handling blades (the blades
must be carried in a support when this is
possible) and raw materials.
Operation in complete safety
- Choose a saw blade suited to the material to be
cut.
- Do not use the saw to cut materials other than
those recommended by the manufacturer.
- Only use the saw with protective guards in good
working order and correctly maintained and in place.
- Keep the ground surface free of loose materials,
for example chips and dust.
- Check that the speed marked on the blade is at
least equal to the speed marked on the saw.
- Check that all the spacers and clamp rings for the
spindle used are suited to their use according to the
manufacturer's indications.
- When a laser is provided: warning that exchange
for a laser of different type is not permitted.
Instruction that repairs must be made by the laser
manufacturer or an authorised agent.
- Refrain from removing any debris or any other part
of the piece to be machined from the cutting zone
whilst the machine is operating and when the saw
head is not in the rest position.
- How to make cuts correctly and in complete safety:
- always fix the piece to be cut firmly to the
saw support.
- before each cut check that the tool is still
stable and fixed.
- if necessary fix the tool to a work bench or
similar.
- always fix the piece to be cut firmly onto
the saw support.
SAVE THESE INSTRUCTIONS
INSTALLATION
Bench mounting
When the tool is shipped, the handle is locked in the
lowered position by the stopper pin. Release the
stopper pinby simultaneously applying a slight
downward pressure on the handle and pulling the
stopper pin.

FUNCTIONAL DESCRIPTION

WARNING:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking
function on the tool. Failure to switch off and
unplug the tool may result in serious personal injury
from accidental start-up.
Blade guard (G)
When lowering the handle, the blade guard rises
automatically.
The blade guard returns to its original position
when the cut is completed and the handle is raised.
WARNING:
• Never defeat or remove the blade guard or the
spring which attaches to the guard. An exposed
blade as a result of defeated guarding may result in
serious personal injury during operation.
In the interest of your personal safety, always
maintain the blade guard in good condition. Any
irregular operation of the blade guard should be
corrected immediately.
Check to assure spring loaded return action of
guard.
1