Rane Seventy Guide D'utilisation page 11

To change which Serato DJ Pro effect is applied to a deck in Software Effects mode:
1. Hold Shift and then press the FX button corresponding to the effect. The FX button will flash.
2. Turn the Parameter Knob to scroll through effects.
3. When the effect you'd like to apply is displayed, press the Parameter Knob. The FX button will stop
flashing.
Editing Live Effects on a Deck
The main Display screen will show the FX tempo for each deck, which will automatically match the tempo
of the song playing on the deck (unless you manually change this setting as described below). The Display
will also show the FX beat division and depth level for each deck.
To change which deck is in focus on the Display, push the FX Joystick left and right. The FX tempo field
for the deck in focus will be highlighted.
To edit a deck's FX tempo, turn the Parameter Knob or press the Tap button two or more times at the
desired BPM while the deck is in focus on the Display.
Note: After you manually edit a deck's FX tempo, the setting will not reset even after loading a new song to
the deck. To make a deck's FX Tempo go back to automatically matching the tempo of the track loaded on
the deck, press the Parameter Knob or press and hold the Tap button for three seconds while the deck is
in focus on the Display.
To edit a deck's FX beat division, push the FX Joystick up or down while the deck is in focus on the
Display.
To increase or decrease a deck's FX depth level, turn the Depth Knob for the deck.
To edit a Flex effect parameter while in Flex FX Mode:
1. Hold Shift and press the FX button for the effect. This will take you to the Flex effect parameter Display
screen.
2. Highlight the parameter you want to adjust with the FX Joystick.
3. Turn the Parameter Knob in order to adjust the parameter.
4. Press the Parameter Knob to return to the main Display screen.
Note: Changes made from the Flex effect parameter Display screen will not be saved upon powering off
Seventy. To learn how to change the default Flex FX parameters, see
Pad Modes
This chapter describes the different pad modes. Each deck
has eight pads, which are always in one of these modes,
and each deck's pads can be in a different mode. Press
one of the Pad Mode buttons to enter the corresponding
pad mode on that deck. With each press, a Pad Mode
button will alternate between a primary and secondary pad
mode. When you enter a primary pad mode, the
corresponding Pad Mode button will be lit with its primary
color. When you enter a secondary pad mode, the
corresponding Pad Mode button will be lit white, while the
other Pad Mode buttons will be lit red.
Settings Menu.
3
1 2
5 6 7
4
8
11