Rane Seventy Guide D'utilisation page 10

Operation
Looping
Each deck on the Seventy is equipped with three buttons on the top panel that you can
use to easily create and modify loops. Each button has a primary function (printed
above the button) and a secondary function (printed below the button).
To activate an autoloop of a track playing on a deck, press the deck's Loop On/Off
(Reloop) button. The length of the loop in bars will depend on your software's current
loop size setting. If the current setting is not the loop size you want, you can change
the loop size.
To change the autoloop size, use the x1/2 (Loop In) button to divide the number of bars in half or the x2
button (Loop Out) to double the number of bars. You can change the loop size either before you activate a
loop or while a loop is active and playing.
To deactivate an autoloop of a track playing on a deck, press the deck's Loop On/Off (Reloop) button.
To activate the last used loop on a deck, hold Shift and press the Loop On/Off (Reloop) button on the
corresponding deck while the previously looped track is still playing. The same segment of the track that was
looped before will be looped again.
To activate a manual loop of a track playing on a deck, use the deck's x1/2 (Loop In) and x2 (Loop Out)
buttons. Press the x1/2 (Loop In) button to set the start point for the loop, then press the x2 (Loop Out) button
to set the end point for the loop. After you set the end point, the loop will automatically begin playing.
To deactivate a manual loop of a track playing on a deck, press the deck's Loop On/Off (Reloop) button.
Effects
With the Seventy, you can activate software effects or the internal Flex FX on one or both decks.
Applying Effects to a Deck
To activate software or internal effects on a deck, use
the deck's Effects Toggle. Latch the toggle in the up
position to apply effects to a deck. Alternatively, you can
pull the toggle down and then let go in order to momentarily
apply effects to the deck.
To deactivate software or internal effects on a deck,
place the deck's Effects Toggle in the center position.
To select whether the Effects Toggles activate software or internal effects, press the FX Mode button.
When set to Flex FX Mode, the FX Mode button will be lit blue. When set to Software Effects mode, the
button will be lit amber.
Note: If using the internal Flex FX, you can activate one effect, which will be applied to both decks. If using
Serato DJ Pro software effects, you can stack up to three different effects on each deck. If you would like to
use only one Serato DJ Pro effect on each deck, set Serato DJ Pro to Single FX Mode. If you would like to
use multiple Serato DJ Pro effects on each deck, set Serato DJ Pro to Multi FX Mode. See the Serato DJ
Pro manual if you need more help with this process.
To change which Flex effect is applied while in Flex FX Mode, press the corresponding FX button
(Echo, Reverb, Brake, Flanger, Phaser, or Delay).
To select/deselect a Serato DJ Pro effect while in Software Effects mode, press the corresponding FX
button. The FX buttons to the left of the FX Mode button will correspond to Bank A software effects
(routed by default to Deck 1), and the three FX buttons to the right of the FX Mode button will correspond
to Bank B software effects (routed by default to Deck 2). Names of Serato DJ Pro effects will be visible on
Seventy's Display.
10