Connecting The Digital Surround Processor With Analog Components - Sony MDR-DS5100 Mode D'emploi

Connecting cables (sold separately)
Use the POC-5AB (mini-plug y rectangular plug, sold separately) when connecting the digital
output mini-jack on portable DVD players, portable CD players, or other digital components to
the DIGITAL IN jack.
Optical digital selector (sold separately)
Use of the SB-D30 (Optical digital selector (3-line input, 2-line output), sold separately) is
recommended when connecting more than one digital component.
Notes on optical digital connecting cable
• Do not drop objects on the optical digital connecting
cable or expose the cable to shocks.
• Grasp the plug to connect or disconnect the cable.
• Be sure that the ends of the optical digital connecting
cable are kept clean. Dust at the ends of the cable can
degrade performance.
• When storing the system, attach the cap to the end of the
plug and be careful not to fold or bend the optical digital
connecting cable with a bend radius less than 25 mm.
Connecting the digital surround processor
with analog components
Use an audio cord (sold separately) to connect to the audio output jacks on the VCR,
TV, or other component to the LINE INPUT (L/R) jacks on the digital surround
processor.
Digital surround
processor
To LINE INPUT jacks
Audio left (L, white)
Audio right (R, red)
Connecting cables (sold separately)
Use the RK-G129 cable (stereo mini-plug ˜ pin plug x 2) when connecting the stereo mini-jack
(line out jack or headphones jack) to the LINE INPUT jacks.
In this case, set the volume on the player at around 5 to 7. Noise can occur if the volume on the
player is set to a low setting.
See page 31 for details about other connecting cables (sold separately).
To audio output jacks
Audio left (white)
Audio cord
(sold separately)
The bend radius of the optical
digital connecting cable should be
at least 25 mm.
VCR, TV, or other
component
Audio right (red)
(Continued)
Operation
25 mm
GB
15