Connecting The Digital Surround Processor With Digital Components - Sony MDR-DS5100 Mode D'emploi

Connecting the digital surround processor
with digital components
Use the supplied optical digital connecting cable to connect the optical digital output
jack on a DVD player (or LD player), digital satellite tuner, or other digital component
to the DIGITAL IN jack of the digital surround processor.
Digital surround
processor
To DIGITAL IN jack
Notes
• The optical digital connecting cable is an extremely high-precision device and is sensitive to
jolts and external pressure. Therefore, be careful when inserting and removing the cable plug.
• This system is not provided with the AC-3 RF jacks, and so AC-3 RF signals from LD players
cannot be directly input.
• The digital input for the digital surround processor does not support sampling frequencies of
96 kHz. Set the digital output setting for the DVD player at 48 kHz when using this system.
Noise may be heard when a 96 kHz digital signal is input.
DTS
• A DTS-compatible DVD player is required for the playback of DVDs recorded in
DTS audio. (For more details, see the instruction manual of the DVD player.)
• When playing back sources recorded in DTS audio, press the INPUT button on the
processor to select "DIGITAL".
• When playing LDs and CDs recorded in DTS format, noise may occur at the start of
playback or when fast forwarding. This is not a malfunction.
GB
14
Operation
Optical digital connecting cable (supplied)
Take off the cap on the jack, match the orientation of the plug
with the jack, and then insert until the plug fits into place.
DVD player, LD player, digital
satellite tuner, or other digital
component having an optical
digital output jack
To optical digital
output jack