Storage; Environmental Protection - EMAK BCH 400 BP Manuel D'utilisation Et D'entretien

Idle screw T is adjusted in order to ensure a good
safety margin between idle running and clutch
engagement.
WARNING: With the engine idling (3000
rpm), the blade should not
recommend that you have your nearest
authorised dealer or service workshop carry
out any carburettor adjustments.
WARNING: Weather conditions and
altitude may affect carburation.
MUFFLER
WARNING! - This muffler is fitted with a
catalytic converter needed for the engine to be in
compliance with the emissions requirements.
Never modify or remove the catalytic converter:
failure to do so is a violation of law.
WARNING! - Mufflers fitted with catalytic
converters get very hot during use and remain
so for some time after stopping. This also
applies at idle speed. Contact can result in burns
to the skin. Remember the risk of fire!
CAUTION! - If the muffler is damaged, it
must be replaced. If the muffler frequently
becomes blocked, this could be an indication that
the efficiency of the catalytic converter is limited.
WARNING: Do not operate your brush
cutter if the muffler is damaged, missing or
modified. An improperly maintained muffler
will increase the risk of fire and hearing loss.
EXTRA MAINTANANCE ADVISABLE
It is advisable to inspect the machine by a
specialized technician at an authorized service
network at the end of season, if used
intensively, and every two years if with normal
use.
ATTENTION: All maintenance operations
not reported in this manual must be carried
out by an authorized Service Center.
To ensure steady and regular brush cutter
operation, remember that parts must only be
replaced with ORIGINAL SPARES.
of non-original replacement parts may result
in serious injury or death to the operator or
rotate. We
third parties.

10. STORAGE

If the machine is to be stored for long periods:
- Drain and clean the fuel tank in a well-ventilated
area. To drain the tank, start the engine and
wait until the fuel is exhausted and the engine
stops (leaving fuel mixture in the carburettor
could damage the membranes).
- The procedures for returning the machine to
service following winter storage are the same as
for starting up during everyday use (page 26).
- Follow all the maintenance regulations
previously described.
- Clean the brush cutter completely and lubricate
the metallic parts.
- Remove, clean and lubricate the blade to
prevent rusting.
- Remove the blade fixing flanges, clean, dry
and lubricate the bevel gear seat.
- Empty the fuel tank and put the cap back on.
- Thoroughly clean the cooling slots and the air
filter (B, Fig. 19).
- Store the brush cutter in a dry place, preferably
not in direct contact with the floor and away
from heat sources.

11. ENVIRONMENTAL PROTECTION

Environmental protection should be a priority of
considerable importance when using the
machine, for the benefit of both social cohesion
and the environment in which we live.
- Try not to cause any disturbance to the
surrounding area.
- Scrupulously comply with local regulations
and provisions for the disposal of waste
materials after mowing.
- Scrupulously comply with local regulations
and provisions for the disposal of oils, petrol,
batteries, filters, deteriorated parts or any
elements which have a strong impact on the
environment. This waste must not be
Any unauthorized changes and/or use
GB
35