Important - Alesis ZONEMIX 6 Manuel D'utilisation Du Propriétaire

ZONEMIX 6 QUICK START OWNER'S MANUAL
Quick Setup Diagram
There are many potential setups for the ZoneMix 6, and the diagram below represents only one
possibility. Study the diagram first, and then follow the connection steps below:
1. Before making any connections, be sure all gain settings are at "zero" and all
devices are off.
2. Connect all input sources.
3. Connect the stereo outputs to the power amplifier(s) and/or audio receivers such as
tape decks.
4. Plug your mixer into AC power. Now you are ready to switch everything on.
IMPORTANT: Always switch on your audio input sources such as turntables or CD players
first, then your mixer, and finally any amplifiers. When turning off, always reverse this
operation by turning off amplifiers, then your mixer, and then input devices.
Neutrik™ "Combo" connector proper wiring – This will allow the use of either 1/4" or
XLR connectors depending upon the switch position. You should wire your connections
according to the following chart details:
2
MODE:
Line Stereo:
Line Mono:
Mic Balanced:
Mic Unbalanced:
(ENGLISH)
1
3
POSITION
1=ground, 2=left, 3=right
1=ground, 2=signal, 3=ground
1=ground, 2= "+", 3= "-"
1=ground, 2=signal, 3=ground
6-Channel Stereo Analog Line Mixer with Two Independent Zone Outputs
TUNER
tip
sleeve
ring
+ -
gnd
2 3 1
- 3 -