Installation Dimensions; Preparation For Mounting - Pelgrim ISW1000RVS Notice D'utilisation

INSTALLATION

Installation dimensions

250
465
500
ISW1000RVS

Preparation for mounting

EN 12
250
250
min.50
ø 150
970
1000
Preparing the recess
• Determine the location for the recess in relation to the hob, either in
the ceiling or in the chimney.
• The hood is fitted with a temporary suspension system with sliders
to make it easier to mount. To use this system, the recess must
have a suspension flange to suspend it temporarily (maximum
height 115 mm). Attention: the flange must be sufficiently strong to
support the cooker hood across 4 points.
• The ceiling/chimney must be fitted with a bar that has a minimum
thickness of 36 mm to which the extraction hood can be attached
with the 4 screws. Remember to check the position of the mounting
holes.
• Preferably fix the bars so the short sides are parallel to each other.
250
120
600 565
ISW1200RVS
250
250
min.50
ø 150
1170
1200
120