Technical Specifications - Toolland TM 76010 Mode D'emploi

TM 76010
Fix the cutter by fastening the bolts,

opposed to the direction as shown.
To replace the other cutter, rotate the

cylinder 180° and repeat the steps
described above.
Always unplug the tool before replacing

the cutters.
Adjusting a cutter
Set the planning depth to 0.

Turn the screws in or out to determine

the correct adjustment. The cutter is
properly adjusted when the cutting edge
touches the surface of the work piece.
Setting the planning depth
Turn the adjustment knob until the

desired planning depth is reached.
The depth setting can be read from the

scale.
Mounting and setting the parallel fence
The parallel fence is used for planning

along edges.
Loosen the fixing screw.

Hold the parallel fence right across its

width against the side of the machine.
The groove should engage in the bracket.

Insert the mounting screw from the

opposite side of the machine into the
mounting hole and turn it into the
bracket.
Securely tighten the mounting screw.

Tighten the fixing screw.

To set the parallel fence, proceed as

follows.
Loosen the set screw.

Set the parallel fence to the required

distance.
Tighten the set screw.

USE
Switching on and off
To switch the tool on, keep the lock-off

button depressed and press the on/off
switch.
To switch the tool off, release the on/off

switch.

TECHNICAL SPECIFICATIONS

Voltage
Frequency
Power
www.toolland.eu
Speed
Planing width
Max. planing depth
Weight
Level of sound pressure measured according
to EN-standard:
Lpa (Sound pressure)
Lwa (Acoustic power)
Weighted root mean square acceleration
value according to EN-standard:
WARANTY
Refer to the enclosed warranty conditions for
the terms and conditions of warranty.
ENVIRONMENT
Should your machine need replacement after
extended use, do not put it in the domestic
waste but dispose of it in an environmentally
safe way.
230V
50Hz
600W
English
16.000t/min
82mm
2mm
2,7kg
88 dB(A)
k= 3dB(A)
101 dB(A)
k= 3dB(A)
4,5 m/s² k= 3dB(A)
11