Braun 7 Série Mode D'emploi page 14

1
2
14
Description
Clean&Renew station
Cleaning fl uid display
1
Lift button for cartridge exchange
2
Station-to-shaver contacts
3
Start button
4
Fast clean button
D
Cleaning program indicators
5
Station power socket
6
Cleaning cartridge
7
Shaver
Foil & Cutter cassette
8
Cassette release button
9
Shaver head lock switch
0
Pop-out long hair trimmer
q
On/off switch
w
– setting button (sensitive)
e
+ setting button (intensive)
r
Reset button
t
Shaver display
z
Shaver-to-station contacts
u
Shaver power socket
i
Travel case
o
Special cord set
p
Before shaving
Prior to fi rst use you must connect the shaver to
an electrical outlet using the special cord set
or alternatively proceed as below.
Installing the Clean&Renew station
• Using the special cord set
station power socket
• Press the lift button
• Hold the cleaning cartridge
stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge into the base of the station
as far as it will go.
• Slowly close the housing by pushing it down
until it locks.
The cleaning fl uid display
fl uid is in the cartridge:
up to 30 cleaning cycles available
up to 7 cleaning cycles remaining
new cartridge required
, connect the
p
to an electrical outlet.
6
to open the housing.
2
down on a fl at,
7
will show how much
1
p