Preparing The Appliance; Checking And Controls - Casselin CLV35 Mode D'emploi

Following the technical sheet install adapted electrical, water and drain lines in the area where
the appliance will be placed.
A few basic rules must be observed when using the appliance:
- Never remove it from its original installation site.
- Make sure the water supply gate valve is opened before starting the appliance.
- Never wash the appliance with direct or high pressure water jets.
- Never use corrosive products, acids, steel wool or steel brushes.
- At the end of the daily work session, disconnect the main power turning off the
appliance using the main switch upstream from it.
- Never let your appliance in an environment with temperature under 0°C.
The manufacturer waives all liability for any injury to persons or damage to property due to:
• Disregard of these instructions;
• Maintenance, regulations or repairs not performed by professionally qualified
persons.
• Any modifications, fitted devices or dispensers which could alter the original
operation of the appliance.
• Once the appliance is off and disconnected from the main supply only a qualified
technician can dismantle the panels.

2. Preparing the appliance

Open the water tap and turn on the main switch upstream from the machine. Close the door
and press the line button (A1): the LED (A5) lights. The machine automatically fills with water
and when the level in the tank is reached, the boiler heating element engages. When the water
reaches the good temperature, the heating element will turn off and the heating element of the
tank will go on. Activation of resistance is indicated by the light (A7). A few minutes later, the
machine is ready for use. After a few minutes the appliance will be ready for use. The LED
(A7) will switch off and you can press the start button (A2). The cycle light (A6) will switch on.
3. Checking and control
Operating temperatures
The water supply temperature should be between 55°C and 60°C. The temperature of the
water in the wash tank is regulated by a thermostat settled at about 55°C. This temperature
ensures the proper action of the chemicals content in industrial detergents. The boiler
temperature, set by a thermostat, is at about 85°C. The appliance is fitted with a device that
ensures the correct rinsing temperature. If the temperature of the water supply is below that
indicated in the technical data, the appliance will pause during short washing cycles until the
good rinsing temperature is reached.
Rinse aid dispenser
During the washing, the rinse aid dispenser is enabled to inject the rinse aid in the boiler. The
rinse aid dispenser and its feed tube must be filled before using the appliance. To do this,
make sure that the rinse aid tank is full. To fill the plastic rinse aid feed tube only: make the
machine perform an empty washing cycle. Push on/off cycle button (A1) with short sequences
Version 270114
20