Clatronic BS 1226 Mode D'emploi page 37

4....-05-BS 1226
Upholstery nozzle:
Floor nozzle:
Releasing the accessories: Pull them apart while turning slightly.
Damper
Open the damper on the hose handle to adjust the airflow or to release objects clin-
ging to the nozzle.
Dust bag filling display
Hold the hose up into air. If the dust bag change display lights up, the bag is full.
Please change it.
Changing the dust bag
1. Pull the plug out of the socket.
2. Press the button to open the lid of the dust bag compartment.
3. Remove the dust bag holder and pull the dust bag out of the holder.
4. Insert a new dust bag.
5. Reinsert the dust bag holder.
6. Close the cover so that it snaps into place.
Filter: Your appliance has two filters.
Motor protection filter (inlet filter):
• The inlet filter is located in the dust bag compartment.
• Pull the button on the handle (10) upwards in order to open the housing.
• The filter is located vertically in the rear section of the dust housing.
• Remove the filter by pulling upwards. Clean the engine protection filter after 10
dust bag changes. If necessary, the filter can also be washed in warm water
without any additives.
• Place it back into place only once it is completely dry!
Outlet filter:
• The appliance is also equipped with an outlet filter.
• It is located on the rear part of your appliance behind a ventilation grid.
• Open the ventilating grid by pressing the button on the underside of the grid.
• Pull the grid up and out. Remove the filter and clean as described above.
• Fit the filter back into place and close the ventilation grid by following the steps
above in the opposite order.
28.02.2002 8:52 Uhr
To clean upholstery, curtains, etc.
To clean carpets or smooth surfaces.
Smooth floors:
Press down the lever with the brush symbol with
your foot. The brush is now visible.
Carpets:
Press down the opposite lever.
Seite 37
GB
37