addi quick Mode D'emploi page 18

Felting an addi heart
18
Once a solid and closed surface has formed
(Fig. above), you can move the addiQuick in almost
any direction—in a circle, from right to left, and from
top to bottom.
Be careful not to move the addiQuick tool in the
opposite direction of the needle and ensure the
needle does not become stuck. This will likely
break the needle.
4. Shaping
An indentation is to be shaped at the widest point of
the heart. This is done by lingering with the felting
machine on a specific location (Fig. on page 9).
Simply guide the needle briefly with light pressure
back and forth over the same spot. This results in
a slight indentation.
The deeper the addiQuick needle penetrates the