S+S Regeltechnik KINASGARD ABWF/LF Notice D'instruction page 7

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

G
Light sensor and motion detector
Light sensor
40°
30°
20° 10°
50°
60°
70°
80°
90°
100°
1.0
0.8
0.6
40°
30°
20° 10°
50°
60°
70°
80°
90°
100°
1.0
0.8
0.6
Characteristic curve showing the sensor's sensitivity
in function of the angle of incidence of light.
NOTES (W):
This device is used for the detection of persons in up to 10 meters distance. The temperature difference between persons to be detected and
ambience must be greater than 5 K. When motion is detected, the potential-free relay output switches. The hold time for the output, measured
from the time when last motion was detected, can be pre-set between 4 seconds and ca. 16 minutes. The sensor is characterized by its wide
reach while being small in size. The potential-free changeover contact is used for switching extra-low voltage only.
®
In all KINASGARD
motion sensors and presence detectors, a high-end variant infrared sensor with enlarged angle of aperture is exclusively used.
Because of the patented lens system with 20 individual lenses, only very small dark areas are resulting, which even at a distance of 10 m are only a
few centimeters wide, safely detecting also small motions. The sensor recognizes changes in the infrared radiation spectrum, so in heat radiation,
resulting form the movement of persons or objects. Such movements generate a temporary change of the temperature gradient in the field. Because
of the always present body (heat) radiation, this sensor is excellently suitable for the detection of persons. The temperature difference between
sensor and object must be > 5 K.
Aperture angle
Top view
X
10m
55°
5m
5m
55°
10m
High-end variant infrared sensor with enlarged aperture angle of 100°
respectively 110° over 360 degrees circumference and 10 m of reach.
1.0
ABWF ⁄ LF
0.8
0.6
0.4
0.2
0
0.4
20° 40° 60° 80° 100°
1.0
0.8
0.6
0.4
0.2
0
0.4
20° 40° 60° 80° 100°
Side view
10m
5m
5m
10m
PHOTASGARD
®
Light sensor
120%
100%
80%
60%
40%
20%
AHKF
Characteristic curve showing the sensor's
sensitivity in respect of the wavelength of light.
The broken line represents the light perception
of the human eye.
The sensor used in PHOTASGARD
was specifically adapted to the sensitivity of the human eye.
Its greatest sensitivity is in the range of 350 nm to 820 nm.
Therefore with its special filter the sensor is predestined for
exposure measure ment of daylight and ⁄ or for measuring
artificial light of high colour temperature (similar to sunlight).
®
KINASGARD
Detection range
Y
46,5°
Principle
46,5°
Sensor recognizes the temperature difference resulting from
the movement of persons or objects.
CIE
0%
300
400
500
600
Motion sensor
Infrared
radiation
Temperature
difference
Motion
PHOTASGARD
®
SENSOR
700
800
900nm
®
light intensity sensors
®
KINASGARD
KINASGARD
®
Infrared
radiation

Publicité

Table des Matières
loading

Table des Matières