Basic Cleaning - SOLAC CE4497 Mode D'emploi

- That Icon (4) will remain lit, fixed indicating that
the water has reached the necessary tempera-
ture for generating steam.
- Place a recipient under the steam tube.
- Open Steam knob (R) anticlockwise.
- Steam only will begin to exit.
- When you have enough, close the control and
remove the recipient.
MPORTANT
- When you finish doing steam, you must re-
fill the water used to make steam, because the
temperature of making steam, is very high,
and reduced the water in the boiler. While you
refill the boiler, at same time, you get the right
temperature (lower) for making coffee.
- To do it, do as per "Getting Hot water"
GETTING HOT WATER:
- Put the device in ON situation, pressing the
knob Espresso ON/OFF (F).
- The heating icon (2) will blink on the display
(D).
- Blinking means it has started to heat up.
- When (2) remains fixed, it indicates that it has
reached the appropriate temperature.
- Place a container under the nozzle.
- Open the steam control (R), turning him to the
left, counterclockwise.
- The hot water began to come out of the vapor-
izer.
- Once obtained the desired amount of hot water.
- Close The turning knob (R) to the right, clock-
wise.
- The machine will stop supplying water.
FOR DRIP COFFEE
- Make sure there is enough water in the tank.
- Fill the Permanent Filter (O) for drip coffee,
using a measuring spoon.
- Use a maximum of 2 spoonful of coffee, not
too fine.
- Properly place the Drip Filter Holder (N) with
the Drip Filter (O) in the machine.
- Place the thermos jug (S) under the coffee
spout.
- Press the Drip Coffee Switch (E).
- On Display (D), the Drip Coffee Icon will light
up (7).
- The machine will start making coffee.
- When you have finished making coffee, the
machine will emit a warning sound 3 times and
then the machine will automatically turn off.
- You can take out the thermos jug (S) when the
coffee has stopped coming out.
AUTO-OFF FEATURE:
- The SOLAC machines are designed to save
energy
- To that end, after some minutes from the last
operation, the unit switches to energy saving
mode
- To return to normal operation you should just
Switch OFF and Switch ON the connect button
(F)
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off, using the on/off switch
(F) to OFF
- Unplug the appliance to the mains.
- Remove the water from the water tank.
- Clean the appliance
CLEANING

BASIC CLEANING

- Disconnect the appliance from the mains and
let it cool before undertaking any cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Neither parts of this appliance are suitable for
cleaning in the dishwasher.
- After washing, dry all the parts before fitting
them together and storing.
CLEANING THE FROTHING WAND
- CAUTION! The frothing wand, and frothing
sleeve may be VERY HOT.