Firmware Update - dji Osmo Pocket Guide De L'utilisateur

forward and backward (selfie). When Osmo Pocket is not in FPV mode, hold to lock the
gimbal's current attitude, and release to unlock.
5. 8-Pin Connector
Connects with the universal port of the Osmo Pocket.
Installation

Firmware Update

After connecting the Controller Wheel to the Osmo Pocket, firmware updates start automatically
if there is new firmware available. The Osmo Pocket's status indicator blinks green and red
alternatively while updating and lasts for approximately 15 seconds. The Controller Wheel can
be used once the Osmo Pocket's status indicator is solid green.
DO NOT operate the Osmo Pocket or Controller Wheel during a firmware update.
Otherwise, the update may fail.
Wireless Module
Introduction
The OSMO POCKET
and your mobile device, making shooting more flexible and convenient. The Wireless Module
also serves as a charging mount for the Osmo Pocket.
1
2
3
Wireless Module provides a wireless connection for the Osmo Pocket
TM
1. USB-C Port
Connects the Wireless Module to the Osmo Pocket.
2. Status Indicator
Indicates the connection status.
3. Power Port (USB-C)
Connect the Wireless Module to a USB charger to charge
the Osmo Pocket.
The Controller Wheel can be
m o u n t e d w h e t h e r t h e O s m o
Pocket is powered on or off. DO
NOT operate the Control Dial while
connecting the Controller Wheel to
the Osmo Pocket. Otherwise, the
gimbal may drift. In that case, tap
on the Osmo Pocket screen and
go to settings, and select "Dial
Calibration" in the Accessories
menu.
3