Measuring Temperature; Measuring Frequency; Measuring Dutycycle; Additional Features - Amprobe 34XR-A Mode D'emploi

6. Connect the Test Probes across the capacitor. When measuring an electrolytic
capacitor match the test lead polarity to the polarity of the capacitor.
7. Read the display.

Measuring Temperature

1. Set the Function Switch to °C or °F.
2. Connect the K-type thermocouple to a TEMP adapter (XR-TA).
Match the polarity of the adapter to the polarity of the thermocouple.
3. Connect the TEMP adapter to the  and COM inputs.
Note: The 34XR-A is compatible with all K-type thermocouples. The
K-type bead thermocouple supplied with the meter is not intended for
contact with liquids or electrical circuits.
4. Expose the thermocouple to the temperature to be measured.
5. Read the display.

Measuring Frequency

1. Set the Function Switch to Hz.
2. Connect the Test Leads: Red to Hz, Black to COM
3. Connect the Test Probes to the signal source.
4. Read the display. The Meter will autorange for the best resolution.

Measuring Dutycycle

1. Set the Function Switch to %.
2. Connect the Test Leads: Red to %, Black to COM
3. Connect the Test Probes to the signal source.
4. Read the display. The Meter will autorange for the best resolution.

ADDITIONAL FEATURES

Input Test Lead Warning

The meter emits a continuous tone when a test lead is placed in the μA mA or
10A input jack and the Function/Range Switch is not set to a correct current
position. (If the meter is connected to a voltage source with leads connected
for current, very high current could result). All current ranges are protected by
fast acting fuses.
See Figure -10-
See Figure -11-
See Figure -12-
5