Normal Operation - SATA air star C Mode D'emploi

9. Normal Operation

Note!
Before each use, carry out a functionality test with the half mask.
This comprises:
■ Check the rubber seal, head bands as well as lower bands (see chap-
ter 10.4)
■ Check the expected useful life of the activated carbon adsorber / of
the activated carbon filter (see chapter 9.1)
■ Check the inputs and outputs (see chapter 10.3)
In addition, a leak test is to be carried out with the half mask (see chap-
ter 9.4).
9.1. Checking the service life
Note!
Before each use, the expected useful life of the activated carbon ad-
sorber / of the activated carbon filter is to be checked. If the expected
useful life (max. 3 months) is exceeded, it must be replaced.
■ Check the expected useful life of the activated carbon adsorber / of the
activated carbon filter and replace it if necessary (standard model see
chapter 10.1, alternative model see SATA filter 464 operating manual).
9.2. Fitting the belt unit
The belt unit [7] / [8] can be adjusted individually through the adjustable
belt.
■ Adjust length / circumference of the belt unit accordingly.
■ Put on belt unit [3-2].
■ Close belt unit using the clasp [7-1] / [8-1].
9.3. Put the half mask on
Health risk from poisoning
If the half mask does not fit tightly to your face, pollutants can penetrate
from the outside.
→ Tighten both ends of the head strap until the half mask fits tightly to
your face.
Operating manual SATA air star C
Warning!
EN
109