Charging; To Use; Care And Storage - Beurer FC 65 Mode D'emploi

6. Charging

Charge the device for at least six hours before first use.
1. Insert the power cord connector into the charging base. Plug the power cord plug into a standard 110
VAC electrical outlet.
2. Place the facial brush into the charging base from above. While charging, the blue LED in the brush
head will flash. When the battery is fully charged, the blue LED will illuminate steadily.

7. To Use

1. Press the Brush Head onto the spindle of the brush handle. To remove, pull on the Brush Head firmly.
2. Moisten the Brush Head with water. Do not use dry.
3. Apply cleansing gel to your face.
4. To switch on the device, press the ON/OFF/Speed Button.
5. The device has three speed settings, low, medium, and high. To change, press the ON/OFF/Speed
Button.
6. Use the Function Button to select between vibration (for gentle cleansing) and pulsation (for thorough,
intense cleansing).
7. If you have problem skin, you can press the Light Button to activate the blue LED during use for a
noticeable softer-feeling and radiant-looking skin. While the brush is in pulsation mode, the blue LED
will cycle on and off.
8. Press the brush head gently against your face and use even movements to remove residue, dirt, and
dead skin cells. Treat each section of skin for a maximum of 20 seconds. The brush features a 1-minute
timer and pauses every 20 seconds to indicate that you should move the brush head to a different area.
The facial brush will shut off after one minute, which is the maximum recommended treatment time.
9. To shut the device off manually, press and hold the ON/OFF/Speed Button for about one second.
10. Rinse your face thoroughly with clean water, then pat dry with a soft towel and apply moisturizing
cream if desired.

8. Care and Storage

WARNING
• Unplug the power cord before cleaning the charging base.
• Only clean the device in the manner specified. Never let water or other liquids get inside the device or
accessories.
• Do not use the device again until it is completely dry.
• Do not clean the device in the dishwasher.
• Do not use aggressive cleaning agents or stiff brushes.
Unplug the charging base and allow it to cool. Clean it with a soft, slightly moistened cloth, then wipe dry
with a soft, lint-free cloth.
To clean the brush head after each use, pull it from the brush handle and rinse under running water.
To reorder a replacement brush head, contact customer service. We recommend replacing the brush head
after every four months of use.
Disposal
Observe the local regulations for material disposal. Dispose of the device in accordance with local
regulations. If you have any questions, please contact the local authorities responsible for waste disposal.
5