Installation Guide - AMIX AFF-2 Série Manuel Utilisateur

INSTALLATION GUIDE

It is good practice to plug in all the equipments before power on.
A/ Connections:
 Plug in CAP65 sensor to AFFseries-2.
 Connect AFFseries-2 to the power supply
 For the first time, plug AFFseries-2 directly to your computer using the RJ45 port
(LAN on the rear panel). Attention, use a cross RJ45 wire.
 If you intend to use the dry loop outputs, use an other RJ45 wire.
Connect AFFseries-2 GPI/GPO 2 outputs to the remote equipment such as AFF05 display
etc... Otherwise make no connection.
CAP65
PS 12V
AFF series-2
AFFseries-2 internal memory
setting, reading and analysis.
B/ Starting :
 Stand alone :
AFFseries-2 features a web server allowing to control from you favorite web browser. Open
your browser, enter AFFseries-2 IP address into the address window.
Default factory IP address is : 192.168.0.25.
http://
You can now access the web pages to set, analyse and read the AFFseries-2 internal memory.
Attention, in case of difficulties, follows the procedure in "technical tools" annex
 Use on a net :
Connect AFFseries-2 to the net using the RJ45 connector.
Attention : To work properly the AFFseries-2 IP address should be unique on the network, and
in the available IP range. Should the PC or routeur net differ from AFFseries-2, first modify PC or
routeur to the same net as AFFseries-2, then set AFFseries-2 IP address as described in
"technical tools" annex.
AMIX
GPO1/GPO2 OUT
pour relier un afficheur AFF04
192.168.0.25
PS 12V
AFF series-2
AFFseries-2 internal memory
setting, reading and analysis.
34
CAP65
GPO2 OUT
pour relier un
afficheur AFF05
AFFseries-2