Gardeo GFBHT65-12TBS950 Traduction Des Instructions D'origine page 42

STEP 5: Attach Front Support Leg and Handle Bar to the Beam
1. Attach the front support leg (#12) to the beam (#1) secure using hex bolt M10x90 (#14), flat
washer Ø10 (#15), lock washer Ø10 (#16) and nylon lock nut M10 (#17). Then fix the lock pin
(#13).
2. Attach the handle bar (#81) to the beam (#1) using flat washer Ø16 (#77) and cotter pin Ø4x30
(#75).
STEP 6: Attach Engine
1. Attach the engine (#47) to the wheel stand using hex bolt M8x65 (#65), flat washer Ø8 (#23),
lock washer Ø8 (#22) and nylon lock nut M8 (#19). Put polyurethane block (#63) and big flat
washer Ø10 (#64) in the middle engine and engine mounting plate.
42