Assembly & Installation - Glow Fire Bio Burner 24 Guide D'utilisation

Thank you for choosing our bio ethanol fireplace. Bio-ethanol fireplaces are the environmentally
friendly solution for a real fire, without smoke, soot and ashes. They are suitable for living rooms
without a chimney and do not require a permit. Our fireplaces are made of stainless steel and / or
black powder-coated steel and impress with a modern concept.
Our bio-ethanol fireplace is a fireplace that you can use anywhere in the house or in your apartment.
Since bio-ethanol burns almost residue-free, ventilation through an open window is sufficient.
Before using the fireplace, please read the operating instructions carefully.
This product may only be sold together with this manual.
In the event of a resale, these instructions must be attached urgently.
Assembly & installation
For safety reasons, we recommend installation by specialist personnel.
It is recommended to install the fireplace with at least two or more people. Make sure the fireplace is
on a solid wall with non-combustible material. Please remove all packaging and packaging materials
before assembly and commissioning.
Wall mounted fireplace assembly:
- It is recommended to mount the brackets into the studs of a wall. If there isn't a stud, use
the drywall anchors to mount the brackets. Mount the top bracket first. Make sure the
mounting brackets are level. Drill a hole into the wall. Place the anchors into the hole. Place
the bracket over the anchor and screw through the bracket into the anchors.
- Measure the distance between the top holes and the bottom holes in back of the fireplace.
- Mount the bottom brackets based on the distance between the top and bottom holes in the
back of the fireplace.
- Drill a hole into the wall for the bottom bracket then put the drywall anchor into the hole.
- Place bottom bracket over the anchor in the wall and screw through the bracket into the an-
chors.
- Have 1 person hold the fireplace over the mounted brackets while the 2nd person inserts the
screws and washers through the holes into the brackets.
- Make sure the wall fireplace is mounted with the topside up. Fuel canisters will not tip over
in fuel can holder if the fireplace is topside up.
- Make sure the fireplace is securely mounted to the wall before adding fuel gel.
Installation of a free-standing fireplace:
- The free-standing fireplace is fully assembled and there is no further assembly
- required
- If you have a device with contact protection disks, these must be mounted using the brackets
provided.
- Make sure that the fireplace has sufficient stability. In addition, the fireplace must stand ab-
solutely straight. Measure this with a spirit level. Otherwise, ethanol may leak.
- Place the fireplace on a heat-resistant surface.
- Place the bioethanol burner in the fireplace.
Fireplace User Guide & Safety Instructions
2