Kicker PX.2 Série Manuel D'utilisation page 2

Authorized KICKER Dealer:
Purchase Date:
Serial Number:
PERFORMANCE
Model:
RMS Power
@ 2 stereo,  1% THD+N
@ 4 stereo,  1% THD+N
Length, in. [cm]
Height, in. [mm]
Width, in. [mm]
Frequency Response ± 1dB
Signal-to-noise Ratio
Input Sensitivity
Electronic Crossover
Pro Tip: To get the best performance from your new KICKER Amplifi er and extend the warranty by 1 year, use
genuine KICKER accessories and wiring.
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no items
behind the area where the screws will be driven. Choose a location that allows at least 4" (10cm) of open
ventilation for the amplifi er. Drill four holes using a 7/64" (3mm) bit and use the supplied #8 screws to mount the
amplifi er.
Wiring: Disconnect the vehicle's battery to avoid an electrical short. Then, connect the PX harness to the
amplifi er. Connect the ground wire to a paint-and-corrosion-free, solid, metal area of the vehicle's chassis,
making it no longer than 24" (60cm). Adding an additional ground wire of this same gauge (or larger) between the
battery's negative post and the vehicle chassis is recommended.
2
2012 PX 100.2 Rev F.indd 2 2012 PX 100.2 Rev F.indd 2
PX.2-SERIES AMPLIFIERS
OWNER'S MANUAL
MODEL: PX100.2
PX100.2
50W x 2
25W x 2
6-5/16" [17.6]
2" [50.6]
3-1/2" [88.2]
20Hz–20KHz
>85dB, A-weighted, re: rated power
Low Level: 125mV–5V
High Level: 250mV–10V
Selectable 100Hz, 250Hz or OFF; 24dB/octave
11/29/2011 2:45:41 PM 11/29/2011 2:45:41 PM