Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
sTeP 7:
(see FIGure 7)
THIS STEP FOR MODEL 45-0471 ONLY
•
Assemble the deflector rod (I), washer (GG), and
connecting rod (H) to the deflector (F) using the
thread forming screw (EE). Tighten the screw until it
is just snug and then back it off 1/4 turn or until the
deflector rod (H) will slide freely.
GG
ee
FIGure 7
sTeP 8:
(see FIGure 8)
THIS STEP FOR MODEL 45-0471 ONLY
•
Remove the bolt, washers and nuts that are
assembled in the upper hole in the right hopper tube.
•
Attach the deflector rod (I) to the upper hole in the
hopper tube using the original bolt, washers and nut
that were removed. Attach the deflector rod to the
empty middle hole in the hopper tube using a 1/4"
self threading screw (EE).
FIGure 8
I
F
h
I
OrIGINaL
FasTeNers
ee
sTeP 9:
(see FIGure 9)
THIS STEP FOR MODEL 45-0471 ONLY
•
Attach the push rod clamp (JJ) and the eye clamp
(KK) to the right side of the handle tube. You may
need to gently tap the clamps into the holes in the
tube with a hammer.
FIGure 9
sTeP 10:
(see FIGure 10)
THIS STEP FOR MODEL 45-0471 ONLY
•
Slide the push rod (G) up through the eye clamp (KK)
and then clip it into the push rod clamp (JJ).
•
Attach the push rod to the connecting rod using a 1/4-
20 x 3/4" hex bolt (DD) and a 1/4-20 nylock nut (FF).
•
Install the grip (LL) onto the end of the push rod.
G
FIGure 10
6
JJ
KK
G
LL
JJ
FF
KK
dd
Publicité
Table des Matières
