Setting The Clock; Before First Use - Krups KM480 Mode D'emploi

a Machine body
b Lid
c Water tank
d Water level indicator
e Carafe lid
f Carafe handle
g Carafe
h Warming plate
„ Place the coffee maker on a hard flat surface.
„ Connect the power cord to a 220V-240V wall socket.
– When you plug in the coffee maker for the first time, "12:00" will start flashing on the
display. Fig. 1. Set the time by pressing the HR button (m) to set the hour and the MIN
button (n) to set the minutes. The time will appear on the display. It will be automatically
set after 5 seconds or by pressing the ON/OFF button (k).
NB: Your clock is now set and will continue to show the time, even when your machine
is in standby mode. If you want to set the time again, push and hold the HR button for 5
seconds.Then, repeat the steps above to reset the clock.
If the machine is unplugged or there is a power failure, the clock will default to 12:00.
Repeat the steps above to reset the clock.
„ Remove stickers from your coffee maker.
„ Before using your coffee maker for the first time, run a cycle without coffee to rinse the
circuit. Fill the water tank to the maximum level and start a cycle by pressing the ON/ OFF
button (k).
IMPORTANT: your machine has been designed to work with cold or water at room
temperature only.
10
DESCRIPTION
i Filter holder
j Spoon
k ON/OFF button
l PROG button
m HR button
n MIN button
o PRE-INFUSION button
p 1 - 4 cups button

SETTING THE CLOCK

BEFORE FIRST USE