Making Coffee; Other Features - Krups KM480 Mode D'emploi

„ Open the coffee maker lid (b). Fig. 3.
„ Fill the carafe (g) with cold or water at room temperature, then pour it into the water tank
(c) Fig. 4.
„ The number of cups is shown by the markings on the carafe and by the water level
indicator. Do not exceed 10-15 cups. Fig. 5.
„ Place the carafe (g) with its lid (e) onto the warming plate (h) making sure that it is properly
positioned so as to activate the coffee pouring mechanism. Fig. 8.
„ Make sure that the filter holder (i) is inserted. Fig. 6. Insert a permanent filter or a paper
filter into the filter holder (i). If using a paper filter, make sure it is fully open and properly
positioned in the filter holder. Fig. 7.
„ Add 1 spoon (j) of ground coffee per cup. Do not exceed 10 spoons (70g). Fig. 9.
„ If you accidentally pour ground coffee into the water tank, do not start the cycle. Clean
the tank, otherwise the coffee may block the water circuit.
„ Close the lid (b).
„ Press ON/OFF button (k) to start the cycle. The ON/OFF button indicator will come on to
show that the coffee maker has started the brew cycle. Fig. 10.
„ Once the cycle has finished, the keep warm function switches on automatically for a
duration of 30 minutes. At the end of the keep warm time, the brew indicator light turns
off.
„ To stop the machine during the cycle, press the ON/OFF button.
Note:
„ The amount of coffee in the carafe at the end of the cycle is less than the amount of water
poured into the tank because about 10% is absorbed by the ground coffee and the filter.
„ There is an overflow hole on the back of the water tank. If you add too much water, it will
leak out of this hole.
„ Clean your permanent filter between each use or use a new paper filter.
CAUTION:
„ To avoid any overflow, the carafe must be properly positioned on the warming plate
of the coffee maker, otherwise it could cause hot water or hot coffee to overflow.
„ The coffee maker becomes very hot during the brew cycle. Please handle with care.
– AUTO START FUNCTION (PROG)
Programming the auto-start settings
„ Your appliance is equipped with auto-start program.
„ Check whether the clock is set to the right time. If not, follow the instructions in the
SETTING THE CLOCK section.
„ Press the PROG (I) button to set the time. The AUTO icon will appear on the display. Fig.
11.
„ Set the time by pressing the HR button (m) to set the hour and the MIN button (n) to set
the minutes. The time set is automatically set after about five seconds. Fig. 12.
„ Starting an auto start function when time has already been set.
– See the section MAKING COFFEE.
– Press PROG button (l) instead of ON/OFF button. The time already set will light up.

MAKING COFFEE

OTHER FEATURES

11