Ruwido easytip Z1 Mode D'emploi page 13

In case it does not, the
channel select function. It simulates the channel switch
function.
Press and hold the (F) key until the LED flashes
Step 1
twice.
Enter the code 1122 (within 5 seconds). The LED
Step 2
will flash twice to confirm correct input.
You can now switch the channels by pressing the
(Programme +) and (Programme -) keys.
If your remote does not work properly with these
functions, maybe the wrong code was programmed. If so
try the other codes in the code list or run the automatic
code search mode.
To deactivate this mode, repeat the two steps above, but
enter 1121 instead of 1122.
Contacting the Helpline
The customer HELPLINE is there to assist you, however, to save
making wasted calls most common questions and problems have
been addressed in the manual. We strongly recommend you
familiarise yourself with the operation of the remote by reading
this manual in detail.
U s e r M a n u a l
has an alternative
easytip Z1
Helpline 00800 31133113
13