Brightness Control - Nicols LED STROB 3 Manuel D'utilisation

On this mode ,this light will be synchronization response the program effect with the master
light which hang over on the master line : Master running mode : Built-in program mode, Auto
run mode, Sound active mode: 1, Sound active mode , Brightness control mode.
Break the main light, this light will be automatic quench.
3.6 DMX mode
Press MODE button. Enter DMX control mode "d--.". Press SETUP button. Enter setup DMX
address menu "×××.". Press UP or DOWN button. Set up the DMX address "001.～512.".
CH1 CH2
DIM 1 FLASH 1
DIM FLASH
SPEED

3.7 Brightness control

Press MODE button. Enter brightness control menu "CON". Press SETUP button, Enter
brightness control men"×××".Press UP or DOWN button. Set up brightness value "000～
255". Press SETUP button. Enter brightness control mode strobe flash setup menu "FS.×".
Press UP or DOWN button. Setup flash value "FS.0～FS.9"
PS
When power supply display software version "v ×.×",,display time is 2 seconds .
Within 20 seconds there is no touch with any button, LED display will be closed.
CH3 CH4 CH5
DIM DIM
FLASH 2
2 3
No use
No use
No use
CH6
Value
FLASH 3
0-34
35-69
70-104
105-139
140-174
175-209
210-244
245-255
5-
CH7
Function
Dimmer & Flash
Dimmer & Flash
Pr01
Pr02
Pr03
Pr04
Sound1
Sound2