Haier HCW7819EWMP Mode D'emploi page 27

Masquer les pouces Voir aussi pour HCW7819EWMP:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 90
Use
EN
Notice
1. The temperature of filling drinks in the kettle should not exceed 60 ℃ .
2. If there is more splashing water in the bracket, please wipe it gently in time, otherwise
it may affect the automatic water filling function.
3. Make sure the kettle is installed in place.Otherwise, the automatic water injection function
may fail or water overflow!
4. Missing to rotate and disassemble fruit tea according to the direction indicated by the arrow.
5. Drink the tea in the kettle within 24 hours, and too much time will easily cause deterioration
6. The kettle should be cleaned in time if it is filled with tea or not used for a long time
7. The kettle can be filled with just water without adding fruit or tea.
7.2 Clean
7.2.1Take off the cover;
7.2.2 Divide the lid into upper lid, lower lid and fruit tea leak.
7.2.3 Clean the kettle and its parts with a soft sponge dipped in water.
7.2.4 Use a diluted dishware cleaner to remove stubborn stains.
Rinse with water after stains are removed.
Notice
The temperature of clean water cannot exceed 60℃
Do not use dishwasher for cleaning;
7. Water Kettle function introduction
7.1-1
This product is a fruit tea kettle with cold water, users need to
open the top cover, and then add the fruit tea.
Then the kettle is placed in the bracket to be automatically
filled with water , and taken as needed to use(Fig.7.1-1).
Only model HCW7819EHMP is available with automatic water refill.
(If there is no automatic water injection function, please
manually put the water into the kettle)
7.1 Use
7.1.1 From the handle side, lift up along the edge of the upper
cover to open the upper cover;
7.1-2
7.1.2 Fruit slices or other tea products can be placed in the fruit
tea leak;
7.1.3 When installing the fruit tea sifter and the lower cover, it
can be disassembled by rotating according to the direction of
the arrow and installed in reverse;
7.1.4 When the kettle need to be placed on the bracket, the
spout downward slightly and put it in.(Fig.7.1-2)
7.1.5 When the kettle is taken out by the kettle bracket, lift the
handle up and draw it out horizontally
Use
;
23

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hcw7819ehmp

Table des Matières