Procedure To Program The Air Filter - Panasonic NE-2153-2 Mode D'emploi

Masquer les pouces Voir aussi pour NE-2153-2:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 58
How to Operate NE-2153-2/NE-1653
N. Procedure to Program the Air Filter
(Continued on next page.)
To Select Pitch of Tone
There are 3 options for the pitch of tone at the end of the heating cycle.
: Low,
: Normal (Factory Setting),
8. Within 3 seconds after touching Prog Pad at Step 7, touch Start Pad.
A. "PROG" will start to blink.
B. Current pitch of tone will be displayed.
C. The display changes to " ", " ", and "
settings change (Under the "bE" in "bEEP").
9. When the desired pitch of tone has been selected, touch Prog Pad again.
"PROG" will stop blinking, and the set pitch of tone at the end of heating cycle will
appear for 3 seconds. Then "0" will appear.
To proceed to set pitch of filter cleaning alarm, touch Start Pad before "0" is displayed
after Step 9.
To Select Pitch of Filter Cleaning Alarm
There are 3 options for the pitch of the filter cleaning alarm.
: Low,
: Normal (Factory Setting),
10. Within 3 seconds after touching Prog Pad at Step 9, touch Start Pad.
A. "PROG" will start to blink.
B. Current pitch of filter cleaning alarm will be displayed.
C. The display changes to " ", " ", and "
settings change (Under the "EP" in "bEEP").
11. When the desired pitch of filter cleaning alarm has been selected, touch Prog Pad
again.
"PROG" will stop blinking, and the set pitch of filter cleaning alarm will appear for
3 seconds. Then "0" will appear.
Note: When the programmed hour of cleaning Air Filter is "0", the pitch of filter
cleaning alarm can not be selected.
1. Open the door and leave it open.
The oven lamp will turn on. "0" will appear in the Digital Display Window.
2. While touching Start Pad, touch Number Pad "7".
3. The display will show the length of time (in hours) between cleaning the Air Filter you
have programmed in or the original time preset by the manufacturer.
4. Set the desired time between cleaning by touching the appropriate Number Pads.
(Up to 9999 hours)
[Example]: Touch Number Pads "6", "0" and "0" for 600 hours.
: High
" each time Start Pad is touched and the
: High
" each time Start Pad is touched and the
- 24 -

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ne-1653Ne-2143-2Ne-1843Ne-1643

Table des Matières